Automated PBX failover
Transfer connected system interfaces to a matching standby UCM6510 when the active unit fails.
Grandstream HA100 High Availability Controller for Two UCM6510 PBXs
RRP $680.90
49% OFF
Not sure what you need?
Read our complete guide.
Not sure what you need?
Read our complete guide.
RRP $680.90
49% OFF
Grandstream • SKU HA100
An automated failover controller designed to connect and monitor two matching Grandstream UCM6510 IP PBXs.
The HA100 is an automated failover controller for a pair of matching Grandstream UCM6510 IP PBXs. It monitors the primary and secondary systems and can switch telecom lines, network connections and auxiliary links to the standby unit when a failure is detected. Grandstream states an overall system switch time of approximately 10 to 50 seconds, depending on the number of registered SIP endpoints.
Quick answer: Choose HA100 only for a validated two-UCM6510 high-availability design. The controller does not include the two PBXs and is not specified for the UCM6300 family.
Transfer connected system interfaces to a matching standby UCM6510 when the active unit fails.
Use up to 14 front-panel LEDs to monitor connected interface and failover status.
Build a controlled legacy UCM6510 resilience design with matched configuration and wiring.
A quick fit check for Australian businesses comparing equipment for users, rooms, sites or wider projects.
| Exact model | HA100 |
|---|---|
| Required PBXs | 2 × matching UCM6510 units, sold separately |
| Failover time | Approximately 1050 seconds, endpoint dependent |
| Indicators | Up to 14 LEDs |
| Network behaviour | Includes gratuitous ARP during failover |
| Scope | Controller only; UCM6510 PBXs not included |
It monitors two matching UCM6510 PBXs and switches connected system interfaces to the standby unit after a detected failure.
No. The HA100 is the controller only; both matching UCM6510 systems are sold separately.
Grandstream specifies the HA100 for UCM6510. Do not assume UCM6300 compatibility.
Grandstream states approximately 10 to 50 seconds depending on the number of registered SIP endpoints.
It is designed to switch connected telecom lines, network and auxiliary interfaces in the supported UCM6510 design.
The HA100 provides up to 14 LEDs for interface and system status.
Yes. A successful high-availability design requires matched firmware, configuration and connections.
Yes. Provide both PBX models, firmware, trunks, extensions, network diagram and continuity objectives.
Monitor the active and standby UCM6510 systems in a supported configuration.
Move connected telecom, network and auxiliary paths to the standby system.
Plan for the published 1050 second switch interval based on system scale.
View connected interface and failover state from the front panel.
Help update network reachability during the supported failover sequence.
Build the solution around two separately supplied, matching UCM6510 PBXs.
Best for: existing UCM6510 installations that require a planned, tested and documented hardware failover design.
| DigiPhone SKU | HA100 |
|---|---|
| Product type | High-availability failover controller |
| Verified PBX | Grandstream UCM6510 |
| PBX quantity required | 2 matching units, sold separately |
| Failover time | Approximately 1050 seconds, depending on registered SIP endpoints |
| Indicators | Up to 14 LEDs |
| Network failover | Gratuitous ARP supported |
| Interfaces | Telecom, network and auxiliary connections for supported UCM6510 design |
| Lifecycle | Legacy UCM6510 accessory; confirm current support |
| Package scope | HA100 controller; PBXs not included |
| Manufacturer warranty | 1-year Grandstream manufacturer warranty |
Compatibility note: Confirm two matching UCM6510 PBXs, firmware, configuration, trunks, network, auxiliary wiring, endpoints, testing and lifecycle.
| SKU | HA100 |
| Barcode # | 6947273702382 |
| Brand | GRANDSTREAM |
| Shipping Weight | 3.1000kg |
This DigiPhone listing is supplied as an Australian version and is covered by a one-year Grandstream manufacturer warranty in Australia, subject to Grandstreams terms for this exact product. Warranty service is subject to the manufacturers terms and proof-of-purchase requirements.
Your rights under this warranty are in addition to rights available under the Australian Consumer Law. Keep your DigiPhone invoice and product serial number for any claim.
Bulk and project support: For fleet deployments, spare units or warranty planning, contact DigiPhone with the SKU and required quantity.
Grandstream • SKU HA100
An automated failover controller designed to connect and monitor two matching Grandstream UCM6510 IP PBXs.
The HA100 is an automated failover controller for a pair of matching Grandstream UCM6510 IP PBXs. It monitors the primary and secondary systems and can switch telecom lines, network connections and auxiliary links to the standby unit when a failure is detected. Grandstream states an overall system switch time of approximately 10 to 50 seconds, depending on the number of registered SIP endpoints.
Quick answer: Choose HA100 only for a validated two-UCM6510 high-availability design. The controller does not include the two PBXs and is not specified for the UCM6300 family.
Transfer connected system interfaces to a matching standby UCM6510 when the active unit fails.
Use up to 14 front-panel LEDs to monitor connected interface and failover status.
Build a controlled legacy UCM6510 resilience design with matched configuration and wiring.
A quick fit check for Australian businesses comparing equipment for users, rooms, sites or wider projects.
| Exact model | HA100 |
|---|---|
| Required PBXs | 2 × matching UCM6510 units, sold separately |
| Failover time | Approximately 1050 seconds, endpoint dependent |
| Indicators | Up to 14 LEDs |
| Network behaviour | Includes gratuitous ARP during failover |
| Scope | Controller only; UCM6510 PBXs not included |
It monitors two matching UCM6510 PBXs and switches connected system interfaces to the standby unit after a detected failure.
No. The HA100 is the controller only; both matching UCM6510 systems are sold separately.
Grandstream specifies the HA100 for UCM6510. Do not assume UCM6300 compatibility.
Grandstream states approximately 10 to 50 seconds depending on the number of registered SIP endpoints.
It is designed to switch connected telecom lines, network and auxiliary interfaces in the supported UCM6510 design.
The HA100 provides up to 14 LEDs for interface and system status.
Yes. A successful high-availability design requires matched firmware, configuration and connections.
Yes. Provide both PBX models, firmware, trunks, extensions, network diagram and continuity objectives.
This DigiPhone listing is supplied as an Australian version and is covered by a one-year Grandstream manufacturer warranty in Australia, subject to Grandstreams terms for this exact product. Warranty service is subject to the manufacturers terms and proof-of-purchase requirements.
Your rights under this warranty are in addition to rights available under the Australian Consumer Law. Keep your DigiPhone invoice and product serial number for any claim.
Bulk and project support: For fleet deployments, spare units or warranty planning, contact DigiPhone with the SKU and required quantity.
Monitor the active and standby UCM6510 systems in a supported configuration.
Move connected telecom, network and auxiliary paths to the standby system.
Plan for the published 1050 second switch interval based on system scale.
View connected interface and failover state from the front panel.
Help update network reachability during the supported failover sequence.
Build the solution around two separately supplied, matching UCM6510 PBXs.
Best for: existing UCM6510 installations that require a planned, tested and documented hardware failover design.
| DigiPhone SKU | HA100 |
|---|---|
| Product type | High-availability failover controller |
| Verified PBX | Grandstream UCM6510 |
| PBX quantity required | 2 matching units, sold separately |
| Failover time | Approximately 1050 seconds, depending on registered SIP endpoints |
| Indicators | Up to 14 LEDs |
| Network failover | Gratuitous ARP supported |
| Interfaces | Telecom, network and auxiliary connections for supported UCM6510 design |
| Lifecycle | Legacy UCM6510 accessory; confirm current support |
| Package scope | HA100 controller; PBXs not included |
| Manufacturer warranty | 1-year Grandstream manufacturer warranty |
Compatibility note: Confirm two matching UCM6510 PBXs, firmware, configuration, trunks, network, auxiliary wiring, endpoints, testing and lifecycle.
| SKU | HA100 |
| Barcode # | 6947273702382 |
| Brand | GRANDSTREAM |
| Shipping Weight | 3.1000kg |
Copyright © 2026 DiGi Phone.
ABN: 49 168 373 519
Welcome to our website. If you continue to browse and use this website, you are agreeing to comply with and be bound by the following terms and conditions of use, which together with our privacy policy govern DiGi Phone’s relationship with you in relation to this website. If you disagree with any part of these terms and conditions, please do not use our website.
The term ‘DiGi Phone’ or ‘us’ or ‘we’ refers to the owner of the website whose registered office is U12 , 35 Redland Drive , VERMONT, VIC, 3133. Our ABN is 49 168 373 519. The term ‘you’ refers to the user or viewer of our website.
The use of this website is subject to the following terms of use:
This privacy policy sets out how we uses and protects any information that you give us when you use this website.
We are committed to ensuring that your privacy is protected. Should we ask you to provide certain information by which you can be identified when using this website, then you can be assured that it will only be used in accordance with this privacy statement.
We may change this policy from time to time by updating this page. You should check this page from time to time to ensure that you are happy with any changes.
What we collect
We may collect the following information:
What we do with the information we gather
We require this information to understand your needs and provide you with a better service, and in particular for the following reasons:
Security
We are committed to ensuring that your information is secure. In order to prevent unauthorised access or disclosure, we have put in place suitable physical, electronic and managerial procedures to safeguard and secure the information we collect online.
How we use cookies
A cookie is a small file which asks permission to be placed on your computer's hard drive. Once you agree, the file is added and the cookie helps analyse web traffic or lets you know when you visit a particular site. Cookies allow web applications to respond to you as an individual. The web application can tailor its operations to your needs, likes and dislikes by gathering and remembering information about your preferences.
We use traffic log cookies to identify which pages are being used. This helps us analyse data about webpage traffic and improve our website in order to tailor it to customer needs. We only use this information for statistical analysis purposes and then the data is removed from the system.
Overall, cookies help us provide you with a better website by enabling us to monitor which pages you find useful and which you do not. A cookie in no way gives us access to your computer or any information about you, other than the data you choose to share with us.
You can choose to accept or decline cookies. Most web browsers automatically accept cookies, but you can usually modify your browser setting to decline cookies if you prefer. This may prevent you from taking full advantage of the website.
Links to other websites
Our website may contain links to other websites of interest. However, once you have used these links to leave our site, you should note that we do not have any control over that other website. Therefore, we cannot be responsible for the protection and privacy of any information which you provide whilst visiting such sites and such sites are not governed by this privacy statement. You should exercise caution and look at the privacy statement applicable to the website in question.
Controlling your personal information
You may choose to restrict the collection or use of your personal information in the following ways:
We will not sell, distribute or lease your personal information to third parties unless we have your permission or are required by law to do so. We may use your personal information to send you promotional information about third parties which we think you may find interesting if you tell us that you wish this to happen.
If you believe that any information we are holding on you is incorrect or incomplete, please write to or email us as soon as possible at the above address. We will promptly correct any information found to be incorrect.
