Extend DECT coverage
Reach approved areas beyond the direct radio range of a compatible base.
Snom M6 Wideband DECT Repeater for M-Series Bases
RRP $290.00
18% OFF
Not sure what you need?
Read our complete guide.
Not sure what you need?
Read our complete guide.
RRP $290.00
18% OFF
Snom • SKU SNOM-M6
A wideband DECT repeater that extends compatible Snom single- or multi-cell coverage without requiring an Ethernet connection.
The Snom M6 extends radio coverage for compatible M300, M400, M700 and M900 DECT bases. It supports up to five simultaneous calls and can place up to three repeaters in series from a base. It is a repeater only: it does not register SIP accounts, replace a base station or bridge two bases in a multicell network.
Quick answer: Choose the M6 only after a DECT coverage survey confirms that a repeater is appropriate. It needs mains power within radio range of the base or preceding repeater and does not require Ethernet.
Reach approved areas beyond the direct radio range of a compatible base.
Install within DECT radio range using a local power outlet rather than Ethernet.
Carry up to five simultaneous supported calls through the repeater.
A quick fit check for Australian businesses comparing equipment for users, rooms, sites or wider projects.
| Exact model | Snom M6 |
|---|---|
| Product type | DECT repeater; base required |
| Compatible bases | M300, M400, M700 and M900 |
| Simultaneous calls | Up to 5 |
| Repeater chain | Up to 3 in series from one base |
| Network | No Ethernet connection required |
| Limitation | Cannot bridge two multicell bases |
It extends DECT radio coverage for compatible Snom M-series base systems.
No. It needs local power and a radio link to the base or preceding repeater.
Snom states up to five simultaneous calls.
No. Snom states that the M6 cannot act as a bridge between two bases in a multicell system.
Compatibility should not be assumed. Confirm the exact Snom model, firmware, platform, network, power and accessory requirements before ordering.
This DigiPhone listing is presented as an Australian version with applicable Australian Consumer Law protections.
Yes. Contact DigiPhone with SKU SNOM-M6, the target platform, site and user quantities and required accessories for compatibility and project support.
Improve approved coverage beyond the bases direct reach.
Support busy mobile work areas within rated capacity.
Use up to three units in series where the design permits.
Place the repeater using DECT radio and local power.
Work with listed Snom M-series base platforms.
Avoid using the repeater as a base-to-base bridge.
Best for: surveyed warehouses, schools, healthcare and multi-zone premises extending a compatible Snom M-series DECT system.
| DigiPhone SKU | SNOM-M6 |
|---|---|
| Product type | Wideband DECT repeater |
| Base support | Snom M300, M400, M700 and M900 |
| Simultaneous calls | Up to 5 |
| Cascade | Up to 3 repeaters in series from one base |
| Audio | Wideband |
| Ethernet | Not required |
| Power | Local power outlet required; confirm supplied PSU |
| Limitation | Cannot bridge bases in a multicell network |
| Updates | Over-the-air support through compatible system |
| Manufacturer warranty | Snom manufacturer warranty in Australia; duration not supplied |
Compatibility note: Confirm M300/M400/M700/M900 base, firmware, regional DECT, power, call load and surveyed repeater topology. M6 is not a base or Ethernet bridge.
| SKU | SNOM-M6 |
| Barcode # | 4260059583725 |
| Brand | SNOM |
| Shipping Weight | 0.5000kg |
| type | SNOM IP PHONES |
This DigiPhone listing is supplied as an Australian version and is covered by the Snom manufacturer warranty in Australia; the duration and service conditions were not stated in the supplied DigiPhone record and should be confirmed for this exact product. Warranty service is subject to the manufacturers terms and proof-of-purchase requirements.
Your rights under this warranty are in addition to rights available under the Australian Consumer Law. Keep your DigiPhone invoice and product serial number for any claim.
Bulk and project support: For fleet deployments, spare units or warranty planning, contact DigiPhone with the SKU and required quantity.
Snom • SKU SNOM-M6
A wideband DECT repeater that extends compatible Snom single- or multi-cell coverage without requiring an Ethernet connection.
The Snom M6 extends radio coverage for compatible M300, M400, M700 and M900 DECT bases. It supports up to five simultaneous calls and can place up to three repeaters in series from a base. It is a repeater only: it does not register SIP accounts, replace a base station or bridge two bases in a multicell network.
Quick answer: Choose the M6 only after a DECT coverage survey confirms that a repeater is appropriate. It needs mains power within radio range of the base or preceding repeater and does not require Ethernet.
Reach approved areas beyond the direct radio range of a compatible base.
Install within DECT radio range using a local power outlet rather than Ethernet.
Carry up to five simultaneous supported calls through the repeater.
A quick fit check for Australian businesses comparing equipment for users, rooms, sites or wider projects.
| Exact model | Snom M6 |
|---|---|
| Product type | DECT repeater; base required |
| Compatible bases | M300, M400, M700 and M900 |
| Simultaneous calls | Up to 5 |
| Repeater chain | Up to 3 in series from one base |
| Network | No Ethernet connection required |
| Limitation | Cannot bridge two multicell bases |
It extends DECT radio coverage for compatible Snom M-series base systems.
No. It needs local power and a radio link to the base or preceding repeater.
Snom states up to five simultaneous calls.
No. Snom states that the M6 cannot act as a bridge between two bases in a multicell system.
Compatibility should not be assumed. Confirm the exact Snom model, firmware, platform, network, power and accessory requirements before ordering.
This DigiPhone listing is presented as an Australian version with applicable Australian Consumer Law protections.
Yes. Contact DigiPhone with SKU SNOM-M6, the target platform, site and user quantities and required accessories for compatibility and project support.
This DigiPhone listing is supplied as an Australian version and is covered by the Snom manufacturer warranty in Australia; the duration and service conditions were not stated in the supplied DigiPhone record and should be confirmed for this exact product. Warranty service is subject to the manufacturers terms and proof-of-purchase requirements.
Your rights under this warranty are in addition to rights available under the Australian Consumer Law. Keep your DigiPhone invoice and product serial number for any claim.
Bulk and project support: For fleet deployments, spare units or warranty planning, contact DigiPhone with the SKU and required quantity.
Improve approved coverage beyond the bases direct reach.
Support busy mobile work areas within rated capacity.
Use up to three units in series where the design permits.
Place the repeater using DECT radio and local power.
Work with listed Snom M-series base platforms.
Avoid using the repeater as a base-to-base bridge.
Best for: surveyed warehouses, schools, healthcare and multi-zone premises extending a compatible Snom M-series DECT system.
| DigiPhone SKU | SNOM-M6 |
|---|---|
| Product type | Wideband DECT repeater |
| Base support | Snom M300, M400, M700 and M900 |
| Simultaneous calls | Up to 5 |
| Cascade | Up to 3 repeaters in series from one base |
| Audio | Wideband |
| Ethernet | Not required |
| Power | Local power outlet required; confirm supplied PSU |
| Limitation | Cannot bridge bases in a multicell network |
| Updates | Over-the-air support through compatible system |
| Manufacturer warranty | Snom manufacturer warranty in Australia; duration not supplied |
Compatibility note: Confirm M300/M400/M700/M900 base, firmware, regional DECT, power, call load and surveyed repeater topology. M6 is not a base or Ethernet bridge.
| SKU | SNOM-M6 |
| Barcode # | 4260059583725 |
| Brand | SNOM |
| Shipping Weight | 0.5000kg |
Copyright © 2026 DiGi Phone.
ABN: 49 168 373 519
Welcome to our website. If you continue to browse and use this website, you are agreeing to comply with and be bound by the following terms and conditions of use, which together with our privacy policy govern DiGi Phone’s relationship with you in relation to this website. If you disagree with any part of these terms and conditions, please do not use our website.
The term ‘DiGi Phone’ or ‘us’ or ‘we’ refers to the owner of the website whose registered office is U12 , 35 Redland Drive , VERMONT, VIC, 3133. Our ABN is 49 168 373 519. The term ‘you’ refers to the user or viewer of our website.
The use of this website is subject to the following terms of use:
This privacy policy sets out how we uses and protects any information that you give us when you use this website.
We are committed to ensuring that your privacy is protected. Should we ask you to provide certain information by which you can be identified when using this website, then you can be assured that it will only be used in accordance with this privacy statement.
We may change this policy from time to time by updating this page. You should check this page from time to time to ensure that you are happy with any changes.
What we collect
We may collect the following information:
What we do with the information we gather
We require this information to understand your needs and provide you with a better service, and in particular for the following reasons:
Security
We are committed to ensuring that your information is secure. In order to prevent unauthorised access or disclosure, we have put in place suitable physical, electronic and managerial procedures to safeguard and secure the information we collect online.
How we use cookies
A cookie is a small file which asks permission to be placed on your computer's hard drive. Once you agree, the file is added and the cookie helps analyse web traffic or lets you know when you visit a particular site. Cookies allow web applications to respond to you as an individual. The web application can tailor its operations to your needs, likes and dislikes by gathering and remembering information about your preferences.
We use traffic log cookies to identify which pages are being used. This helps us analyse data about webpage traffic and improve our website in order to tailor it to customer needs. We only use this information for statistical analysis purposes and then the data is removed from the system.
Overall, cookies help us provide you with a better website by enabling us to monitor which pages you find useful and which you do not. A cookie in no way gives us access to your computer or any information about you, other than the data you choose to share with us.
You can choose to accept or decline cookies. Most web browsers automatically accept cookies, but you can usually modify your browser setting to decline cookies if you prefer. This may prevent you from taking full advantage of the website.
Links to other websites
Our website may contain links to other websites of interest. However, once you have used these links to leave our site, you should note that we do not have any control over that other website. Therefore, we cannot be responsible for the protection and privacy of any information which you provide whilst visiting such sites and such sites are not governed by this privacy statement. You should exercise caution and look at the privacy statement applicable to the website in question.
Controlling your personal information
You may choose to restrict the collection or use of your personal information in the following ways:
We will not sell, distribute or lease your personal information to third parties unless we have your permission or are required by law to do so. We may use your personal information to send you promotional information about third parties which we think you may find interesting if you tell us that you wish this to happen.
If you believe that any information we are holding on you is incorrect or incomplete, please write to or email us as soon as possible at the above address. We will promptly correct any information found to be incorrect.
